© Cesab
5 – 14
T Code(s): 841, 842, 843
Repair manual: Parameters
Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040
Date: 2018-05-01
Applies from serial number: 6384351-
Verifying parameter settings for freely ventilated batteries (lead-acid
batteries)
1.
Charge the battery.
2.
Use the truck in its normal application until the battery indicator shows a
discharged battery (0% on the display).
3.
Disconnect the battery from the truck and allow it to rest for at least two
minutes.
Note:
Do not charge or discharge during this time.
4.
Measure the specific gravity of the electrolyte at ambient temperature.
If the specific gravity is below 1.15 g/cm
3
, the parameter value must be
reduced.
If the value is considerably higher than 1.15 g/cm
3
the risk of damage to the
battery is reduced. At the same time, the operating time of the truck is
reduced. If extended operating time is desired, then increase the parameter
value by no more than one unit.
Note:
Each change should be followed up by a new verification of the parameter
setting.
Verifying the parameter setting for valve-regulated batteries (Exide)
1.
Charge the battery.
2.
Operate the truck in its normal application until the battery indicator
indicates a discharged battery (0% in the display).
3.
Disconnect the battery from the truck and allow it to rest for at least two
hours.
Note:
Do not allow any charging or discharging during this time.
4.
Measure the battery voltage at room temperature.
If the voltage is less than U
end
(see the table below) the parameter value
must be reduced. If the value is considerably higher than U
end
the risk of
damage to the battery is reduced. At the same time, however, the operating
time of the truck decreases. If extended operating time is desired, then
increase the parameter value, but maximum by one unit.
Note:
Each change should be followed up by a new verification of the parameter
setting.
Battery type
Battery voltage while resting,
U
end
Exide
24.24 V
https://www.forkliftpdfmanuals.com/
