© Cesab
11 – 5
T Code(s): 841, 842, 843
Repair manual: Drive gear 2550
Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040
Date: 2018-05-01
Applies from serial number: 6384351-
11.4 Removing the drive gear from the truck (S212S)
1.
Elevate the drive unit approx 190 mm.
2.
Loosen the drive wheel.
3.
Remove the covers.
The top cover is secured with Velcro tape. Be careful when detaching the
cover. Use of a suitable tool is recommended.
4.
Cut off the cable ties of the cable duct on the transistor regulator side and
disconnect cable connections X5 and X60.
5.
Unscrew the retaining screws of the steering console and remove the
steering console and the tiller arm.
6.
Disassemble the speed sensor and disconnect the cable connections Q1
and B1.
7.
Disconnect the motor cables and unscrew the motor retaining screws.
8.
Lift out the motor from the truck.
9.
Insert a plug in the hole in the gear housing to prevent oil leakage when
the gear is removed from the truck.
10. Unscrew the retaining screws of the gear box.
11. Put down the gear and pull it out to the rear edge.
Install in reverse order.
Put a wooden block under the gearbox to facilitate reassembly.
https://www.forkliftpdfmanuals.com/
