C.E.S. Model SDI-50 Manual, Level Adjustments
6.5.13 Courtesy Beep (*5 24)
When the SDI-50 is set up for Repeater Operation it can be programmed
to generate a "Courtesy Beep" one second after the end of each
transmission. This tone is useful for prompting the other party to
begin speaking. Program this function as follows:
*5 (tone) 24 (tone) 1 (tone) ;courtesy beep
*5 (tone) 24 (tone) O (tone) ;no courtesy beep
6.5.14 Ring Counter (*5 25,26)
When the interconnect is set to automaticly answer an inbound
telephone call, it will answer on the 1st, 2nd, 4th, or 8th ring by
setting these switches. Use the table that follows to set the ring
counter to the desired number of rings.
25 26 Ring Count
off off 1st ring
on off 2nd ring
off on 4th ring
on on 8th ring
Example: To answer on 2nd ring enter a "1" for switch *5 25; and a "O"
for switch *5 26.
*5 (tone) 25 (tone) 1 (tone)
*5 (tone) 26 (tone) O (tone)
6.5.15 Interconnect Enable (*5 27)
This enables or disables the interconnect function without affecting
the repeater control function (if used). With this switch turned off,
no interconnect calls are allowed. This differs from the function 7 4
in that it isn´t under mobile control for a temporary state.
*5 (tone) 27 (tone) 1 (tone) ;interconnect enabled
*5 (tone) 27 (tone) O (tone) ;interconnect disabled
6.5.16 Mobile Signalling Wait Time (*5 30,31)
When selectivo signalling is used to call a mobile, these switches set
the length of time the interconnect will wait for the mobile to answer
before disconnecting the land line.
30 31 Wait Time
off off 15 seconds
on off 30 seconds
off on 45 seconds
on on 60 seconds
Page #30
