Page 6
SKU 95112
for technical questions, please call 1-800-444-3353.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of electric shock or injury.
specific safety rules
ground this product.
This Table Saw requires the attachment and use of a UL
approved, 220 volt, grounded, 3-prong, twist lock, electrical Power Cord Plug (not
included). Only a qualified electrician should install the Power Cord Plug. Never
remove the grounding prong or modify the Power Cord Plug in any way. Do not use
adapter plugs with this product. To comply with the National Electric Code, and to
provide additional protection from the risk of electrical shock, this product should
only be connected to a 220 volt, 3-hole outlet that is protected by a Ground Fault
Circuit Interrupter (GFCI).
(see figure a, page 11.)
Maintain labels and nameplates on the table saw.
These carry important infor-
mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
avoid unintentional starting.
Make sure you are prepared to begin work before
turning on the Table Saw.
do not force the table saw.
This tool will do the work better and safer at the
speed and capacity for which it was designed. Do not force the Saw Blade into the
workpiece being cut.
warning!
Keep hands and fingers away from cutting area and Saw Blade. Use
a “push stick” (not included) if necessary.
never leave the table saw unattended when it is plugged into an electrical
outlet.
Turn off the tool, and unplug it from its electrical outlet before leaving.
always use saw blades with a 10” diameter, 5/8” round arbor hole, and rated
at 4150 rpM or greater.
Saw Blades that do not match the mounting hardware of
the Table Saw or that are rated less than the required minimum RPM will run ec-
centrically causing loss of control or may fly off the Saw, resulting in severe personal
injury and/or property damage.
Make sure the table saw is located on a flat, level, sturdy surface capable of
supporting the weight of the table saw and workpieces.
do not use the table saw for cutting metals or for cutting curves.
This will
cause the Saw Blade to break and/or reduce its service life.
Make sure the table of the table saw and surrounding area are clear with the
exception of the workpiece to be cut.
before using the table saw, check to make sure the saw blade is prop-erly
mounted on the saw spindle.
Make sure the Saw Blade is balanced, and is not
cracked or bent.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.