Page 21
SKU 95112
for technical questions, please call 1-800-444-3353.
operating instructions
cutting aids:
pusHsticKs
pusHblocKs
figure K
pushsticks
(not included) are devices used for safely pushing a workpiece through
the Saw Blade (86D) instead of using your hands. Pushsticks can be made in vari-
ous sizes and shapes from scrap wood. The pushstick must be narrower than the
workpiece, with a 90 degree notch on one end and shaped with a grip on the other
end.
(see figure K.)
A
pushblock
(not included) has a handle fastened by
recessed
screws from the
underside. Use a pushblock on non-through cuts.
(see figure K.)
Making a cross cut:
warning!
Make sure the Clear Blade Guard (2B) is lowered over the Saw Blade
(86D) and is working properly to prevent possible injury.
Set the Saw Blade (86D) to the correct depth for the workpiece by turning the Height
Hand Wheel (36E).
Set the Miter Gauge to 0 degrees. Make sure the Miter Gauge Handle (1A) is se-
curely tightened.
Place a support (not included) the same height as the Saw Table (8E) behind the
Table Saw for large workpieces.
The Miter Gauge may be used in either of the two Miter Gauge Grooves in the Saw
Table (8E). When using the left Groove, hold the workpiece firmly against the Miter
Gauge (4A) with your left hand and grip the Handle (1A) with your right hand. When
1.
2.
1.
2.
3.
4.
5.