Page 25
SKU 95112
for technical questions, please call 1-800-444-3353.
Place a support (not included) the same height as the Saw Table (8E) behind the
Table Saw for cut workpieces.
Make sure the workpiece is not touching the Saw Blade (86D).
Plug the Power Cord Plug into the nearest 220 volt, grounded, twist lock, electrical
outlet. Then, turn the Power Switch (17E) to its
“on”
position.
Allow the Saw Blade (86D) to spin up to full speed before feeding the workpiece
into the Saw Blade.
Make sure to
gradually
feed the workpiece into the Saw Blade (86D). Do not attempt
to force the Table Saw to cut faster or greater than its capacity.
When the cut is completed, press the Power Switch (17E) to its
“off”
position.
Then, unplug the Power Cord Plug from its electrical outlet.
Making a compound (bevel) Miter cut:
warning!
Make sure the Clear Blade Guard (2B) is lowered over the Saw Blade
(86D) and is working properly to prevent possible injury.
warning!
When the Saw Blade (86D) is angled to the left, the Miter Gauge (4A)
must be on the
right side
of the Saw Blade. If not, the Miter Gauge could trap the
workpiece, possibly causing kickback and resulting in injury.
Remove the Rip Fence assembly, and install the Miter Gauge (4A) on the
right
side
of the Saw Blade (86D).
Set the Saw Blade (86D) angle and height by loosening the Lock Knobs (26E) and
turning the Height and Tilting Hand Wheels (36E, 30E). Then, retighten the Lock
Knobs.
Set the wood angle by loosening the Miter Gauge Handle (1A) and setting it to the
desired angle. Then, retighten the Miter Gauge Handle.
Place a support (not included) the same height as the Saw Table (8E) behind the
Table Saw for cut workpieces.
Make sure the workpiece is not touching the Saw Blade (86D).
Plug the Power Cord Plug into the nearest 220 volt, grounded, twist lock, electri-cal
outlet. Then, turn the Power Switch (8E) to its
“on”
position.
Allow the Saw Blade (86D) to spin up to full speed before feeding the workpiece
into the Saw Blade.
Hold the workpiece firmly against the Miter Gauge (4A), and push the workpiece
into the Saw Blade (86D).
7.
8.
9.
10.
11.
12.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.