Page 27
SKU 95112
for technical questions, please call 1-800-444-3353.
inspection, Maintenance, and cleaning
warning!
Make sure the Power Switch (17E) of the Table Saw is in its
“off”
position. Then, unplug the Power Cord Plug from its electrical outlet before perform-
ing any inspection, maintenance, or cleaning procedures.
before each use,
inspect the general condition of the Table Saw. Check for proper
guard alignment, damaged V-Belt, binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation.
If abnormal noise or vibration occurs, have the problem corrected before further
use.
do not use damaged equipment.
before each use,
inspect the Saw Blade (86D). Using a dull Saw Blade will cause
excessive wear on the Motor of the Table Saw and will not produce a satisfactory
cut. Replace with a new Saw Blade when needed.
before each use,
remove sawdust from the exterior of the Table Saw and inside the
unit’s Base (9E). Clean the plastic parts with a soft, damp cloth and mild detergent.
Do not use solvents on plastic parts.
periodically,
clean the Saw Table (8E), Rails (1C, 2C, 3C), and Fence Bracket
Body (9C) with gum and pitch remover. Do not allow pitch to accumulate on the
Table Saw.
periodically,
apply a thin coat of paste wax to the Saw Table (8E) so the wood
slides easily while cutting.
frequently,
vacuum or blow out any sawdust from the Motor (53E).
lubrication:
This Table Saw has been lubricated at the factory prior to shipment.
After extended use, you should inspect, clean, and lubricate all moving parts. Clean
before lubricating with a solvent recommended for gum and pitch removal. Then,
lubricate with machine oil.
to replace the V-belts:
This Table Saw uses a three V-Belt (82D) drive system.
To install the V-Belts
(see assy. diagram d.)
:
Remove the Door (23E) from the Base (9E) of the Table Saw.
be careful! when the Hex Head bolts (72d) are loosened, the motor
can come loose and fall, causing personal injury.
Carefully loosen the Hex
Head Bolts (72D) on the Motor Mount Plate, and raise the Motor Mount Plate
(71D) to release tension on the V-Belts.
Remove the old V-Belts (82D).
Place the V-Belts (82D) in position on the Drive Pulley (40D) and the Motor Pul-
ley (80D).
1.
2.
3.
4.
5.
6.
7.
8.
9.
a.
b.
c.
d.