Page 17
SKU 95112
for technical questions, please call 1-800-444-3353.
Lower the Clear Blade Guard (2B) over the Saw Blade (86D).
caution!
Check to make sure no part of the Blade Guard Assembly comes in
contact with the Saw Blade.
(see figure H.)
to adjust the blade guard assembly:
iMportant:
The Spreader (6B) must always be parallel to the Saw Blade (86D)
and in the middle of the cut (kerf) made by the Saw Blade. If the Spreader is not
parallel to the Saw Blade and not in line with the cut (kerf) made by the Saw Blade
the Spreader will interfere with the workpiece, causing poor and unsafe Guard As-
sembly operation.
(see figure H.)
To adjust the Spreader, raise the Saw Blade (86D) fully and to its 90 ° position.
When adjusting the Spreader (6B), use a straight edge ruler lengthwise along the
Saw Blade (86D) to make certain the Spreader is trailing in the middle of the cut
(kerf).
Also, use a 90 degree hand square to make certain the Spreader is perpendicular
to the Saw Table (8E) as is the Saw Blade.
If necessary, align the
front
of the Spreader (6B) with the Saw Blade (86D):
note:
For this Step you may have to lower the Saw Blade (86D).
Loosen the Socket Head Bolts (53D) on the Front Support Bracket (52D).
(see assy. diagram d.)
Align the front of the Front Support Bracket (52D) so that the Spreader (6B) is
parallel to the Saw Blade (86D) and in the middle of the cut (kerf) made by the
Saw Blade.
(see assy. diagram d.)
When finished, retighten the Socket Head Bolts (53D) on the Front Support
Bracket (52D).
(see assy. diagram d.)
To align the
rear
of the Spreader (6B) with the Saw Blade (86D):
Loosen the 12mm Lock Washer (54D) and 12mm Hex Nut (55D) where the
threaded portion of the Guard Support Rod (37E) connects to the Rear Trunnion
Bracket (77D).
(see assy. diagram d and e.)
Turn the Guard Support Rod (37E) on its eccentric. Turning the Guard Support
Rod will move the Rear Trunnion Bracket (77D) left or right.
(see assy. diagrams d and e.)
After the Spreader (6B) is lined up in the middle of the cut (kerf), retighten the
12mm Lock Washer (54D) and 12mm Hex Nut (55D).
(see assy. diagrams b and d.)
To adjust the
height
of the
front
of the Spreader 6B):
Loosen the 8mm Washer (43E) and 8mm Hex Head Bolt (44E) on the front
mounting slot of the Spreader (6B) and move the front of the Spreader up or
down.
(see assy. diagrams b and e.)
5.
1.
2.
3.
4.
a.
b.
c.
d.
5.
a.
b.
c.
6.
a.