Page 13
SKU 95112
for technical questions, please call 1-800-444-3353.
Slide the Fence Bracket Body (9C) back and forth. The Fence Bracket Body should
move freely with about 1/16” clearance between the Fence Bracket Body and Saw
Table (8E) surface.
(see figure e.)
To lock the Fence Bracket Body (9C) in place, lower the Lock Knob (18C).
(see figure e.)
note:
The Measure Scale Lens (26C) on the Fence Bracket Body (9C) should be
pointing on the “0” position. If not, loosen the two Round Hex Screws (28C) on the
Lens Bracket (27C). Then, move the Lens to indicate the “0” position and retighten
the Screws.
(see figure e.)
to install a saw blade:
warning!
Make sure the Power Switch (17E) is off and the Table Saw is unplugged
from its electrical outlet. Failure to do so could result in accidental starting, causing
serious injury.
(see figure f, next page.)
caution!
To avoid accidental cuts, make sure to wear heavy duty work gloves
when installing a Saw Blade (86D - not included).
Lift and remove the Blade Insert (6E) from the Saw Table (8E).
(see figure f.)
Raise the Arbor Extension (6D) to its highest position by turning the Height Hand
Wheel (36E) clockwise. Turn the Tilting Hand Wheel (30E) clockwise or counter-
clockwise to position the Arbor Extension horizontally.
(see figure f.)
Loosen and remove the Arbor Nut (4D) with the Spanner Wrench (85D) provided.
Then remove the Blade Flange (5D).
(see figure f.)
3.
4.
5.
1.
2.
3.
4.
5.