Page 24
SKU 95112
for technical questions, please call 1-800-444-3353.
using the right Groove, hold the workpiece firmly against the Miter Gauge with your
right hand and grip the Handle with your left hand.
Raise the Rip Fence Lock Knob (18C) and remove the Rip Fence assembly.
Set the Saw Blade (86D) angle by loosening the Lock Knob (26E) and turning the
Tilting Hand Wheel (30E). Then, retighten the Lock Knob.
If necessary, loosen the Miter Gauge Handle (4A) and set the Miter Gauge to 0
degrees. Then, retighten the Miter Gauge Handle.
Make sure the workpiece is not touching the Saw Blade (86D).
Plug the Power Cord Plug into the nearest 220 volt, grounded, twist lock, electrical
outlet. Then, turn the Power Switch (17E) to its
“on”
position.
Allow the Saw Blade (86D) to spin up to full speed before feeding the workpiece
into the Saw Blade.
Hold the workpiece firmly against the Miter Gauge (4A), and push the workpiece
into the Saw Blade (86D).
Make sure to
gradually
feed the workpiece into the Saw Blade (86D). Do not attempt
to force the Table Saw to cut faster or greater than its capacity.
When the cut is completed, press the Power Switch (17E) to its
“off”
position.
Then, unplug the Power Cord Plug from its electrical outlet.
Making a bevel rip cut:
warning!
Make sure the Clear Blade Guard (2B) is lowered over the Saw Blade
(86D) and is working properly to prevent possible injury.
warning!
When making a bevel rip cut, the Fence Bracket Body (9C) of the Rip
Fence must be on the
right side
of the Saw Blade (86D). If not, the Rip Fence
could trap the workpiece, possibly causing kickback and resulting in injury.
warning!
NEVER stand directly in the line of the cut. Stand to the side of the
Table Saw to reduce the risk of injury.
warning!
NEVER push a small piece of wood into the Saw Blade (86D) with
your hand. For small pieces of wood, use a pushstick to move wood into and past
the Saw Blade.
Set the angle of the Saw Blade (86D) by loosening the Lock Knob (26E) and turning
the Tilting Hand Wheel (30E). Then, retighten the Lock Knob.
Install the Rip Fence assembly on the
right side
of the Saw Blade (86D) at the
correct distance from the Saw Blade for the cut.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1.
2.
3.
4.
5.
6.