Page 7
SKU 90589
For technical questions, please call 1-800-444-3353.
UNpACKING
When unpacking, check to make sure all the parts shown on the
parts lists
near the end of this manual
are included. If any parts are missing or broken, please
call Harbor Freight Tools at the number shown on the cover of this manual as soon as
possible.
ASSEMbly INSTRUCTIONS
Note:
For additional information regarding the parts mentioned in the following pages,
refer to the
Assembly diagrams near the end of this manual.
With assistance and a proper lifting device, carefully move the Tire Changer to
1.
the desired workplace location. Make sure to position the Tire Changer on a
flat, level, dry, floor surface capable of bearing the weight of the Tire Changer,
operator, additional tools, tires, etc.
Using the four mounting holes located at the Tire Changer’s base as a template,
2.
mark the spots where four 3/8” diameter mounting holes will be drilled in the floor
surface. Then, temporarily set the Tire Changer aside.
Drill the four, pre-marked, 3/8” holes in the floor surface (about 4” deep). Then,
3.
insert a 3/8” expansion plug (not included) in each of the four holes.
Move the Tire Changer back to its original position, making sure to align its four
4.
mounting holes with the four pre-drilled holes in the floor surface. Once the holes
are aligned and the Tire Changer is level, insert four 3/8” bolts (not included)
through the mounting holes and into the expansion plugs. Secure the Tire
Changer to the floor surface by tightening the four 3/8” bolts.
Prior to assembling and using the Tire Changer, it is recommended that you
5.
familiarize yourself with the main components of the unit.
(See Figure A.)
NOTE:
6.
prior to beginning the assembly procedures, make sure to remove
all the additional parts and accessories from the
shipping boxes
that are
included with the Tire Changer.
REV 07g