Page 18
SKU 90589
For technical questions, please call 1-800-444-3353.
OIl
REGUlATOR
SCREW
lUbRICATOR
(IT204)
OIl CAp
FIlTER & pRESSURE
REdUCER
(IT205)
REd NOTCH
JAR SIGHT GLASS
lOCKING RING
JAR
FIGURE G
4.
At least once per month:
Check the oil level in the Lubricator (IT204). If
necessary, remove the Oil Cap. Fill the Tank with SAE 30-weight oil, and replace
the Oil Cap. Also, make sure that one drop of oil is injected into the Tank every
3-4 times the Bead Breaker Pedal (402) is depressed. If necessary, regulate the
rate of oil injection with the Oil Regulator Screw.
(See Figure G.)
After the first twenty days of use:
5.
Re-tighten the Jaws Tightener (218) and the
Screws (214) located on the Turntable Slides (201).
(See Assy. diagram.)
bElT (605)
MOTOR SUppORT (622)
SCREW (618)
MOTOR (601)
FIGURE H
6.
In the event of a loss of power:
Check to see if the Belt (605) is tight. To do
so, remove the Left Cover (8) which is located on the left side of the Body (1).
Regulate the Belt tension by adjusting the Screw located on the Motor Support
(622).
(See Figure H.)
daily:
7.
Check the level of water in the Filter & Pressure Reducer (IT205). The
level must never reach above the Red Notch in the Jar’s Sight Glass. When
necessary, drain the water by turning the Locking Ring clockwise.
(See Figure
G.)
Every 30-40 days:
8.
Dismantle the Jar to remove any solids collected inside it.
(See Figure G.)
