14
When a crimping head is used, press and hold the operating button until the motor stops auto-
matically.
At the end of the cycle, proceed with the phase of returning the oil to the pump reservoir (Ref.
to
§ 3.5
for further details).
CUTTING
OPERATION
Press the start button: this activates the motor of the pump that feeds the
hydraulic head connected to it, pressurising the oil. Keep the button pressed
until the cutting operation is complete. At the end of the cycle the display
will show the maximum pressure reached (P
p
).
At the end of the cycle, proceed with the phase of returning the oil to the
pump reservoir (Ref. to
§ 3.5
for further details).
PUNCHING OPERATION
Press the start button: this activates the motor of the pump that feeds the
hydraulic head connected to it, pressurising the oil. Keep the button pressed
until the punching operation is complete. At the end of the cycle the display
will show the maximum pressure reached (P
p
).
At the end of the cycle, proceed with the phase of returning the oil to the
pump reservoir (Ref. to
§ 3.5
for further details).
3.5) Oil release
The phase of returning the oil to the pump reservoir, or rather to the re-entry of the ram of the
connected hydraulic head, may be carried out in two diff erent ways depending on the release
mode set (Ref. to
§ 4.3
for further details):
With the ERCH remote controller:
- smart mode:
release the GREEN start button (following automatic shut-off of the motor).
- manual mode:
press the RED release button.
With the rocker switch (11) on the pump (only if the remote controller
is deactivated):
- smart mode:
release the control button at the end of the cycle.
- manual mode:
push the control button backwards.
If required, by pressing hard on the mechanical pressure
release button (7), the oil will return to the reservoir whatever
the status of the battery.
7
ENGLISH
P
p
= 547 bar
P
= 0 bar
P
p
= 325 bar
P = 0 bar
