Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
68
Carrying out cutting
Operation
7.3 Carrying out cutting
• The machine has been put into operation, see the chapter "Daily start-up" (page 64).
Carry out the following steps:
1.
Switch off the
"
machinE
"
, see the section "Switching off machine" (page 72).
!
Do not perform the following steps until the diamond saw blade has stopped turning!
2.
Using the
"
crank
handlE
for
cutting
dEpth
adjuStmEnt
"
,
move the
"
diamond
Saw
bladE
"
2
cm
over the surface to be cut, see the chapter "Set-Up" > "Moving cutting
shaft" (page 52).
3.
Using the
"a
llEn
kEy
"
(10 mm), unscrew the
"
cutting
dEpth
locking
ScrEw
"
.
The cutting depth scale can be moved.
4.
Move the
"
cutting
dEpth
ScalE
"
until the
"
cutting
dEpth
pointEr
"
is on the number
0
on
the
"
cutting
dEpth
ScalE
"
.
5.
Using the
"a
llEn
kEy
"
(10 mm), tighten the
"
cutting
dEpth
locking
ScrEw
"
.
Now the cutting depth scale cannot be moved. The zero point has been set.
The cutting-depth zero point has been specified.
Condition:
Specify cutting-
depth zero point
