Cedima • Technical Documentation • Joint Cutter CF•1020 D • Issue date: 21/09/2021
54
Fitting and removing the diamond saw blade
Set-Up
6.3.2 Fitting diamond saw blade
• The machine is switched off and secured against accidental switch-on, see the chapter
"Operation" > "Daily shut-down" (page 72).
• An approved diamond saw blade
• Spanner (17 mm)
• Allen key (10 mm)
Carry out the following steps:
1.
Using a
"
SpannEr
"
(17 mm), loosen the two
"
faStEning
ScrEwS
"
of the
"
hand
guard
"
.
2.
Carefully fold open the
"
hand
guard
".
The hand guard has been opened.
Carry out the following steps:
Move the
"
cutting
Shaft
"
to a position suitable for the
"
diamond
Saw
bladE
"
to be
mounted, see the section "Moving cutting shaft" (page 52).
The cutting shaft is moved to the height of the diamond saw blade to be fitted.
Condition:
Required:
Open hand guard
Move cutting
shaft to height of
diamond saw blade
to be fitted.
