Cebora WIN TIG DC 350 T, Instruction Manual

Page: 34 / 192

34
and the pedal control. Art. 193 may be used in any TIG
welding mode with this accessory.
Controls that include a potentiometer adjust the
welding current from the minimum to the maximum cur-
rent setting by means of power source generator.
Controls with UP/DOWN logic control welding current
from the minimum to the maximum value
18 ERROR CODES
Err. Description Fix
Err.
14-1
Ex
Err. 01
Low IGBT drive voltage Shut off the wel-
ding machine
and check the
supply voltage. If
the problem con-
tinues, contact
the CEBORA as-
sistance service.
Err.
14-2
Ex
Err. 02
High IGBT drive voltage Shut off the wel-
ding machine
and check the
supply voltage. If
the problem con-
tinues, contact
the CEBORA as-
sistance service.
Err.
84-1
Ex
Err. 06
Quality Control (low volta-
ge detected in welding) By selecting
MENU, check
the intervention
voltage that has
been set.
Err.
84-2
Ex
Err. 07
Quality Control (high vol-
tage detected in welding) By selecting
MENU, check
the intervention
voltage that has
been set.
Err.53
Start closed on machine
start-up or on resetting
an error Release the start
button
Err.67
Supply voltage not as per
specifications or lack of a
phase (during start-up)
Check the sup-
ply voltage. If the
problem conti-
nues, contact the
CEBORA assi-
stance service.
Err.74
Thermal cutout Wait until the po-
wer source cools
Err.75
Low H2O pressure Check tank level,
connection and
cooling unit ope-
ration.
16.1 PREPARING THE ELECTRODE
16.2 COOLING UNIT FOR ART. 555. ( ART 1341)
I f you use a water cooled welding torch, use the cooling
unit.
Carriage Art. 1432 is required to position and transport
the welding machine together with the cooling unit.
After filling the tank with coolant fluid, connect the plug of
the mains cable to the AE socket of the welding machine,
then connect the free-hanging three-pin male connector
to connector
AF .
16.3 DESCRIPTION OF THE COOLING UNIT FOR ART.
557
AG- SLOT:
Slot to inspect the coolant fluid level
AH - QUICK-FITTING VALVES : The cooling pipes of the
welding torch are connected to these valves; NB: there
must be no short-circuits.
AI- CAP
AI - CAP.
17 REMOTE CONTROLS
The following remote controls may be connected to ad-
just the welding current for this welding machine:
Art.1260 TIG torch button only (air-cooled).
Art.1256 TIG torch button only (water-cooled).
Art.1262 TIG torch UP/DOWN (air-cooled).
Art.1258 TIG torch UP/DOWN (water-cooled).
Art. 193 Pedal control (used in TIG welding).
Art 1192+Art 187 (used in MMA welding)
Art. 1180 Connection to simultaneously connect the torch