24
CFX-Plus Pro-Sense 8-12 Installation, Commissioning & Operating Manual Approved Document Ref: UI-CFX-Plus-PS-02 Issue 1.0
SETUP & PROGRAMMING
Set Fault Buzzer Volume
There are two levels of volume for the internal fault buzzer, high and low.
Enter the above code and press the ENTER button to increase or decrease
the fault buzzer tone from the previous level.
Setting will change when ENTER button is pressed.
Disable
Mode
Test
Mode
When finished, enter the next
programming code or disable the controls and return DIL switch 6 to ‘OFF’.
Clear All Disablements
Enter the above code and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds.
Any disabled zone, sounder circuit, output or delay will now be enabled.
The panel will bleep to acknowledge the reset.
Disable
Mode
Test
Mode
When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.
Initialize Factory Default Settings
Enter the above code and press the ENTER button.
Then press the ENTER button again and hold for 3 seconds.
All disablements, test modes and programming will revert back to the
factory default settings.
The panel will bleep to acknowledge the reset.
Disable
Mode
Test
Mode
When finished, enter the next programming code or disable the controls and
return DIL switch 6 to ‘OFF’.
2
1
1
1
1
1
2
3
1
RESOUND
SILENCE
RESET
1
3
Mute
Buzzer
4
Test
Lamps
ENTER
RESOUND
SILENCE
RESET
1
2
3
Mute
Buzzer
4
Test
Lamps
ENTER
2
2
2
4
RESOUND
SILENCE
RESET
1
2
3
Mute
Buzzer
4
Test
Lamps
ENTER
Summary of Contents for CFX-Plus Pro-Sense 12
Page 72: ......