.
Terminologies Used
.
Junction Lines -
Telephone Lines provided by the Department of Telecom.
Extension Lines -
Extension Lines mean the EPABX extension lines.
SLT -
Single Line Telephone. It represents the same meaning as “Extension Lines”
.
Programming the PBX
.
To program most of the feature mentioned in this manual, programming Password is to be entered from any of the first 4
extensions (6001, 6002, 6003, 6004) through the following command
:
#
0000 (Here, 0000 is the default Password)
In case of any mistake while programming, dial
to reset or else keep the Handset down and pick up again.
Whenever a correct input is entered, PBX will give one single acceptance tone and when wrong input is given, it will give
three tones.
Optionally most of the programming can be done from a PC if optional “PC Interface Card” is installed and a PC is
connected to the PBX.
.
Alarm
.
Alarm calls can be set for extensions from any of the programming extensions (or even from own extension) as described
below
:
To set Alarm from SLT programming extensions:
Dial #
0000 05 NN HH MM #
Where, NN = Last 2 digits of the extension number
HH = 00
– 23 Hours
MM = 00 - 59 Minutes
Dial #
0000 05 # (To clear Alarm of all extensions)
Dial #
0000 05 NN # (To clear Alarm of “NN” extension)
To set Alarm from your own SLT extension
:
Dial # 4 HH TT
To set Alarm from KTS
:
Pick Up Handset
Dial # 4
Use Jog Dial to select Extension and to enter the Time
Press “SP-PHONE” key to select any of the parameter.
Press “SP-PHONE” key again to Exit.
.
Allowed Table
.
Numbers to be allowed to extensions whose L = 0, are to be defined in this table.
For value of L refer “Junction Dialing
Controls”.
This table has 16 Locations.
Procedure
:
Dial #
0000 + 43 QQ ABCD#
Where QQ= 01 to 16 (16 Locations of the Table)
ABCD= The starting 4 digits of the Tel numbers to be allowed to extension.
For less than 4 digits, dial # at the end of digits.
To clear this Table
, Dial #
0000 + 43 #
To clear a particular location of this table
, Dial #
0000 + 43 QQ #
.
Auto Call Back
.
From Busy Junction Lines
To get a call back when any of the busy Junction lines get free, following is the procedure
:
Dial 9
Get engaged tone
Dial #
Keep the handset down.
As soon as any one of the busy Junction lines gets free, the Extension will ring. It will ring once and the user can pick
handset within 10 secs to get connected to the Junction line.
From Busy Extensions
To get a call back when any of the busy Extension gets free, following is the procedure
:
Dial Extension Number
Get engaged tone
Dial #
Keep the handset down.
As soon as the busy Extension gets free, the called and calling Extensions will ring simultaneously.
.
Auto Call Disconnection
.
Selected extensions can be programmed to disconnect Out going Junction call after talking for a set time.
Procedure
:
Dial #
0000 + 6 NN TT #
Where, NN= Last 2 digits of the Extension Number.
