Cayman Systems 2E-H-W, User Manual

Page: 88 / 170

Using the Command Line Interface Cayman 2E-H-W User’s Guide
4-30
November 2000
The remote network is one router away and the static route is
the best way to reach it;
The remote network is more than one router away but the static
route should not be replaced by a dynamic route, even if the
dynamic route is more efficient.
delete ip static-routes destination-network net_address
Deletes a static route. Deleting a static route removes all information
associated with that route.
WAN Settings
set ip wan option { on | off }
Enables or disables communications through the WAN Ethernet port
in the Cayman 2E-H-W. You must enable TCP/IP functions for the
WAN port before you can configure its network settings.
set ip wan address ip_address
Assigns an IP address to the Cayman 2E-H-W on the wide area
network. The IP address you assign to an Ethernet port must be
unique on your network.
set ip wan broadcast broadcast_address
Specifies the broadcast address for the TCP/IP network connected to
the WAN Ethernet port. IP hosts use the broadcast address to send
messages to every host on your network simultaneously.
The broadcast address for most networks is the network number
followed by 255. For example, the broadcast address for the
192.168.1.0 network would be 192.168.1.255.
set ip wan netmask netmask
Specifies the subnet mask for the TCP/IP network connected to the
WAN Ethernet port. The subnet mask specifies which bits of the
32-bit binary IP address represent network information. The default