www.catgenie.com
1-888-735-3927
19
4.
Clean or cut any hair or debris around Impeller
shaft.
5.
Wash Hopper with gloved hand or scrub brush
to remove any dirt. Make sure the Red Washer is
still in place and the seeping holes are clean on
both sides of the Hopper.
HOW TO CLEAN YOUR CATGENIE
CLEANING THE HOPPER INSIDE & OUT
1.
Follow instructions on page 18 to take
apart the CatGenie.
2.
Pull out Hopper.
3.
The Hopper opens like a book. Since it is
likely dirty or full of water, open into a sink,
tub, or garbage bag. Be sure to keep track
of the GenieBall and Red Washer while you
clean the Hopper.
CLEAN UNDER THE BASE
TIP: Wear gloves when cleaning the Hopper.
1.
Remove the Bowl. If the Bowl is filled with
wet Granules, place it on something like
a trash bag or towel to prevent water from
leaking onto the floor. Remove Scrubber from
Base. Dump the dirty water from the Base
carefully. Keep the Drain Hose in the drainpipe
or toilet.
2.
If you need to move the Base, keep the
Drain Hose elevated to prevent water spilling.
3.
Clean the Base. Remove any Washable
Granules with a gloved hand or hose, making
sure to check every nook and cranny. Dish
soap can be used when cleaning.
1.
2.
3.
2.
3.
4.
5.
4.
Coil Drain Hose under Base as shown above
and reassemble your CatGenie. Make sure Drain
Hose is attached to drainpipe. When returning
Hopper to unit, make sure the Red Washer is on
the Hopper.
5.
Put the Scrubber in with the “feet” up. It
should be loose and to the side of the center pin
in the Base. Then replace Bowl, and check to
make sure it turns freely. Finally, replace Brim
and clip GenieHand to the Arm in its up position.
4.
5.
Make sure
seeping holes
are clean
Make sure
red washer
is in place
