Cassese MACH 1 UNI, User & Parts Manual

Page: 17 / 78

Non contractual document - Cassese France
®
- Document non contractuel
- 17 -
5.C. PROGRAMMING OF POSITION AND WEDGES QUANTITY PER POSITION
-Each press on the button Position Number 24 increments the current position from 1 to 5 then
come back to the position 1. The number of the current position is displayed in reverse.
-Each press on the button Wedge Quantity 25 increments the number of wedges for the current
position from 0 to 5 wedges then come back to 0 wedge.
-The both arrows’ buttons 22 & 23 move the current position.
Move the stapling position, with the help of one of these both buttons, as far as the desired
position. Then by successive press on the button Wedge Quantity 25 select the desired quantity
of wedges for this stapling position.
-When a position doesn’t exist (no position marked), the corresponding quantity indicates “ - “.
The crossbar doesn’t move if the position doesn’t exist, wherever it is located (the current measure
is indicated on the first line of the screen to the right). When the current position doesn’t exist,
the fact of pressing on the button Wedge Quantity 25 or the both arrows’ buttons 22 & 23 valid
the current position.
-During a moving with the help of the both arrows’ buttons 22 & 23 , the crossbar stops in limit
position rebate clamp side or table side. The screen displays “POSITION MINI” or “POSITION
MAXI”.
CAUTION : If the table doesn’t move back completely and the crossbar comes to stop itself
against the table, the engine which controls this movement skids. The software position doesn’t
correspond to the real position. It’s required to reposition the table to avoid skiding then activate
et desactivate the pre-clamp (to reposition the default position).