Opening the main case:
Fully loosen safety screw VS and open the 2 spring clips S1 and S2.
Open the main case. Remove the blade protection case after unscrewing the two screws C1 and
C2 with a 4-mm Allen key.
11
Clean blades and flanges.
Install the blade (teeth in cutting direction). Check the rotation direction indicated on the sup-
port.
Refit the flange and screw, tightening it while immobilising the shaft with the steadying handle.
Close the main case
. Hook up the 2 spring clips and close their levers, then switch on the main
isolating switch.
Lock the main case by screwing the cover safety screw fully home.
REFITTING THE BLADES
IMPORTANT
REMOVING THE BLADES
Disconnect the air supply.
Switch off the machine at the main isolating switch on the right of the machine and lock
it by installing a padlock on the tab.
10-mm Allen key
Blade steadying
handle
USING THE BLADE
STEADYING HANDLE
VI - MAINTENANCE
During this operation, gloves should be worn to handle the
blades and avoid getting your hands caught.
Use the blade steadying handle
provided to immobilise the shaft, loosen
the nut (as a general rule, to loosen the
nuts securing the blade turn the Allen
key in the blade rotation direction), then
remove the flange and the blade.
C1
C2
S1
S2
VS
Summary of Contents for CS 960
Page 4: ...C...
