10
CUTTING THE FIRST PIECE
The moulding is in contact with the mobile stop.
- Unlock button 5.
- Lift your foot from the pedal (clamping position).
- Press button 4 on the control panel (to start the blade).
- Press button 1 continuously with a finger of the left hand. This releases the right blade.
- Grip the arm of the right blade carriage with your right hand and pull it slowly towards
the clamped profile. Make the cut through to the front stop.
- Release button 1 and the blade carriage arm (the carriage returns automatically to back
position).
- Press button 2 continuously with a finger of the right hand. This releases the left blade.
- Grip the arm of the left blade carriage with your left hand and pull it slowly towards the
clamped profile. Make the cut through to the front stop.
- Release button 2 and the blade carriage arm (the carriage returns automatically to back
position).
- Press button 5 to stop the machine.
- Press the pedal: the clamps move to unclamped position.
- Release the piece of cut moulding from the right-hand side.
- Slide the moulding, pushing it from the left table towards the right table.
END OF MOULDING
- Clamping and cutting are visible to the operator. He must therefore check that the hori-
zontal clamp is correctly engaged in the moulding slot and does not create pressure on the end
of the moulding.
If it does, the operator must only use right clamping and cancel the left clamp (
loosen the
handle of the left horizontal clamp and release it towards the back).
- After cutting, if the off-cut or remaining piece of moulding do not drop under gravity
and cannot be retrieved outside the cover, it must be removed by pushing with the next
moulding or a stick.
The operator must never put his
hands inside the case
!
- It is strictly forbidden to cut several lengths of moulding at the same time by stacking
them or placing them one in front of the other.
- When the machine is in use, the workstation must not be occupied by more than one
person. This person is responsible for the controls.
- When cutting a moulding into thin sections, check that no off-cuts get jammed and
prevent the saw from operating correctly.
1
2
3
4
5
Summary of Contents for CS 960
Page 4: ...C...
