9
Lift your foot from the pedal
to activate the clamps. Move
the MOBILE STOP into con-
tact with the moulding and
lock it.
Remove the cursor from
below the moulding.
Measurement of the moulding
slot base is complete.
MEASURING THE SLOT BASE (INSIDE MEASUREMENT)
Slide the CURSOR along the rule and lock it at the required dimension by tightening its locking
screw. Press the pedal to release the clamps. Move the moulding to the cursor aligning the edge
of the slot base with the 45° angle.
MEASURING THE OUTSIDE DIMENSION
CURSOR
RULE
LOCKING SCREW
READING
POINT
CURSOR
MOBILE STOP
LOCKING
HANDLE
READING
POINT
STUD
Slide the stop along the rule to
the required measurement.
Be sure to use the outside rule
for your measurement, with
respect to the stud on the mo-
bile stop block. Lock the stop.
The measurement has been set.
MEASURING THE FIRST PIECE (MOBILE STOP)
Loosen the locking handle of the MOBILE STOP.
45°
Summary of Contents for CS 960
Page 4: ...C...
