CASO DESIGN VacuChef 70, Instruction Manual

Page: 44 / 122

44
 Cleaning bags for reuse
Wash the bags in warm water with a mild dishwashing soap, then rinse them well and
allow them to dry completely before reusing
.
ATTENTION
► Bags used to store raw meats, fish or greasy foods should never be reused due to risk
of contamination.
19 Troubleshooting
The following table may help you narrow down and address minor malfunctions:
19.1 Safety notices
ATTENTION
► Only qualified electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
19.2 Troubleshooting table
Fault Possible Cause To Rectify
Device does not turn
on
Power plug is not plugged in. Plug in the power plug.
Defective power cord Send device to Customer Service
Defect socket outlet Select other outlet
A complete vacuum
is not being created
in the bag.
The open end of the bag is not
completely inside the vacuum
chamber
Position the bag correctly
The bag is defect Select another bag
There is residue on the welding
and the seal Clean the welding / seals and
retry once they are dry
The bag is not being
sealed correctly
The sealing bar is overheating
so that the bag melts
Open the cover on the unit and
let it cool down for a few minutes.
Sealing bar needs to be replaced.
Defect sealing bar.
The bag does not
hold the vacuum
after it has been
sealed
The bag is defective
Select another bag; wrap paper
around any sharp edges within
the bag.
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
Open the bag again and clean
the upper internal part of the bag.
Remove any foreign matter that
might be on the welding bar
before sealing.