6921413
50
SERVICE
4.11
Solenoid Valve
4.11-1
Coil Service
1
Remove the cover from the valve assembly.
2
Disconnect the wires and diode from the coil terminals.
3
Loosen the end cover capscrews. Remove the end
cover and coil. Note the position of coil terminals.
4
Install the new coil and end cover. Make sure that the
terminals are positioned correctly.
5
For reassembly, reverse the above procedures except
as follows:
• Refer to the electrical schematic in Section 3.5 for
correct wire and diode installation.
4.11-2
Valve Service
• Check the plunger in the valve body for freedom
of movement. If jammed or damaged, replace the
solenoid valve as a complete assembly.
RC0204.eps
2
3
4
Coil
Solenoid Valve
Assembly
Summary of Contents for 14J Series
Page 2: ...BLANK...
