cascade corporation 14J Series, Service Manual

Page: 25 / 58

6921413 22
SERVICE
RR0576.eps
RR0574.eps
RR0575.eps
12
14
Cover plate
11
10
9
4.3-3
Drive Group Reassembly
(Continued)
8
Temporarily install the end cover without shims. Tighten
the capscrews sequentially to 9.5 ft.-lbs. (13 Nm).
9
Measure the gap between the end cover and housing in
three places with a feeler gauge or 'Plastigage' thread
and determine the minimum gap.
10
Choose a combination of end cover shims equal to the
minimum gap measured plus the next higher 0.005 in.
(0.12 mm) increment. See examples below:
• For 0.025–0.029 in. (0.64–0.74 mm) measured gap,
use 0.030 in. (0.76 mm) total shim thickness.
• For 0.010–0.014 in. (0.25–0.36 mm) measured gap,
use 0.015 in. (0.38 mm) total shim thickness.
• For 0.009 in. (0.23 mm) or less, use one 0.010 in.
(0.25 mm) shim.
NOTE: Shim Service Kit 670578 contains the shims
listed. A minimum of one 0.010 in. (0.25 mm) shim is
required to seal against leakage:
Qty Part No. Color Thickness
2 6060031 Blue 0.005 in. (0.125 mm)
2 6060032 Brown 0.010 in. (0.254 mm)
2 6060033 Pink 0.015 in. (0.381 mm)
2 6060034 Yellow 0.020 in. (0.508 mm)
11
Remove the end cover. Apply Loctite 515 sealant
(Cascade Part No. 668184) to both surfaces of the shims
and end cover. Install the shim pack and end cover.
Tighten the capscrews to a torque of 9.5 ft.-lbs. (13 Nm).
Remove excess sealant.
12
Install the cover plate and gasket. If the gaskets shows
porosity, apply Loctite 515 sealant to cover face. Install
the four cover plate capscrews and tighten to 6 ft.-lbs.
(8 Nm). Install the center hole plug.
13
Reinstall the drive group to the rotator baseplate as
described in Section 4.3-1.
14
Fill gearcase until oil begins to run from end cover
port. Use Cascade Gear Lube Part No. 656300, or SAE
90 wt. gear lube (AGMA 'mild' 6EP Gear Lube).
8
Housing
End cover