cascade corporation 14J Series, Service Manual

Page: 29 / 58

6921413 26
SERVICE
7
Temporarily install the end cover without shims. Tighten
the capscrews sequentially in 10 ft.-lbs. (15 Nm)
increments to 20 ft.-lbs. (30 Nm).
8
Measure the gap between the end cover and housing in
three places with a feeler gauge or 'Plastigage' thread
and determine the minimum gap.
9
Choose a combination of end cover shims equal to the
minimum gap measured plus the next higher 0.005 in.
(0.12 mm) increment. See examples below:
• For 0.025–0.029 in. (0.64–0.74 mm) measured gap,
use 0.030 in. (0.76 mm) total shim thickness.
• For 0.010–0.014 in. (0.25–0.36 mm) measured gap,
use 0.015 in. (0.38 mm) total shim thickness.
• For 0.009 in. (0.23 mm) or less, use one 0.010 in.
(0.25 mm) shim.
NOTE: Shim Service Kit 670578 contains the shims
listed. A minimum of one 0.010 in. (0.25 mm) shim is
required to seal against leakage:
Qty Part No. Color Thickness
1
1
1
1
671758
671757
670574
674513
Clear/Yellow
Pink
Brown
Blue
0.020 in. (0.50 mm)
0.015 in. (0.38 mm)
0.010 in. (0.25 mm)
0.005 in. (0.13 mm)
10
Remove the end cover. Apply Loctite 515 sealant
(Cascade Part No. 668184) to both surfaces of the
shims. Install the shim pack and end cover. Tighten
the capscrews to a torque of 65 ft.-lbs. (88 Nm).
Remove excess sealant.
11
With the gearcase laying flat, fill with 18 fluid ounces
(540 ml) of Cascade Gear Lube (Part No. 656300) or
SAE 90 wt. gear lube (AGMA 'mild' 6EP Gear Lube).
12
Install the cover plate and gasket. If the gaskets shows
porosity, apply Loctite 515 sealant to cover face. Install
the four cover plate capscrews and tighten to 16 ft.-lbs.
(22 Nm). Install the center hole plug.
13
Reinstall the drive group to the rotator baseplate as
described in Section 4.4-1.
RR0551.eps
RR0552.eps
RR0553.eps
Housing
End Cover
Cover Plate
7
8
9
11
10
12
4.4-3
Drive Group Reassembly
(Continued)