6921413
SERVICE
33
45
°
RR0842.eps
RR0843.eps
RR0859.eps
RR0860.eps
4.6-2
Drive Motor Disassembly
(Continued)
9
Remove the four Loctited capscrews from the flange
with a X10 Torx Socket. Do not use an impact wrench.
CAUTION:
Thread sealant used on the capscrews may
require a small amount of heat to the housing to remove
the capscrews. Use a temperature indicator to prevent
overheating the housing.
10
Turn the flange 45° clockwise.
11
Remove the flange and output shaft by pushing the
output shaft from under the housing and pulling up on
the tapered portion of the output shaft.
12
Remove the flange and thrust bearing from the output
shaft.
13
Remove the load bearing race and flange seal from the
flange.
14
Remove the wiper seal and pressure seal from the
flange using a seal removal tool or modified screwdriver
as shown.
NOTE:
Remove the seals by pushing from the back
side, as shown.
15
Remove the brass shim from the flange.
10
11
14
Modified Screwdriver
9
14
15 13
Flange
12
Flange
Summary of Contents for 14J Series
Page 2: ...BLANK...
