6921413
SERVICE
49
CC0254.eps
R
9
For reassembly, reverse the above procedures with the
following exceptions:
• When installing the rotation bearing assembly on the
faceplate, align and position the heat-treated overlap
zone 'R' on the inner ring gear with the outer race
grease fitting, as shown, at the angle noted above
horizontal.
• If foam seal is installed on baseplate collar, replace
with new seal assembly.
• Apply multi-purpose extreme-pressure NLGI 2 grease
to the teeth of the bearing assembly ring gear.
• After remounting the attachment on the truck, apply
grease to the bearing assembly grease fitting.
Rotate the attachment slowly during this procedure.
Grease
Fitting
Heat treat
zone 'R'
at 60°
Faceplate
Baseplate
9
Back (driver's) View
Back (driver's) View
4.10-2
Bearing Assembly Removal
and Installation
(Continued)
60°
R
CC0298.eps
Grease
Fitting
Heat treat
zone 'R'
at 40°
9
Faceplate
40°
Summary of Contents for 14J Series
Page 2: ...BLANK...
