6921413
SERVICE
19
4.3
Drive Group
(1.2 ci motor)
4.3-1
Drive Group −
Removal and Installation
1
Remove the attachment from the truck as described in
Section 4.1.
2
Remove tubes connecting the motor to the valve.
3
Remove the four capscrews fastening the drive group to
the baseplate. For reassembly, tighten the capscrews
to 24 ft.-lbs. (32 Nm).
4
For reassembly, reverse the above procedures with the
following exceptions:
• After the drive group has been reinstalled, check
the gear case lubricant level. Oil must be up to the
bottom of the fill plug hole. Add oil through top fill
hole. If necessary, fill with Cascade Gear Lube (Part
No. 656300), or SAE 90 wt. gear lube (AGMA 'mild' 6
EP Gear Lube).
RR0570.eps
4.3-2
Drive Group Disassembly and
Service
1
Drain oil out from the bottom housing hole.
2
Remove the drive group from the baseplate as
described in Section 4.3-1.
3
Lay the drive group, pinion down, on two 4 x 4 in.
(10 x 10 cm) wood blocks placed on both sides of
the pinion.
4
Remove the four capscrews fastening the cover plate to
the housing.
5
Remove the center capscrew plug from the cover plate
and install an 3/8 NF capscrew with a minimum thread
length of 2 in. (50 mm). Remove the cover plate by
turning the capscrew clockwise while lightly tapping
around the sides of the cover plate.
6
Remove the four capscrews fastening the end cover to
the housing.
7
Remove the drive motor as described in Section 4.5-1.
Cover
Plate
4
5
3
7
1
6
Housing
End Cover
Housing
RR0569.eps
2
3
End Cover
Level Hole
Top Fill
Hole
Drain Plug
4
Summary of Contents for 14J Series
Page 2: ...BLANK...
