6921413
SERVICE
35
7
5
3
1
6
4
2
RR0731.eps
Spacer Plate
O-Ring
Gerotor
O-Ring
End Cap
14
Star
Point
Scribe
Mark
12
Short Spline
O-Ring
15
RR0647.eps
4.6-4
Drive Motor Reassembly
(Continued)
9
Turn the housing over and clamp across the flange with
the output shaft taper facing down.
10
Lubricate the O-rings and install into the housing,
gerotor set and end cap grooves.
11
Align the output shaft timing dot with the screw hole that
is aligned to the port surface. Use the scribe mark to
help with the alignment.
12
Use the drive splines to align the gerotor star point with
the capscrew hole, as shown.
13
Assemble together the end cap with O-ring, gerotor set
with O-ring, drive (short spline end into gerotor set) and
spacer.
IMPORTANT:
Make sure O-rings are properly seated.
14
Install end cap assembly onto housing while aligning
the scribe marks and capscrew holes. Make sure the
drive engages with output shaft.
15
Install the capscrews into the end cap. Tighten
the capscrews using an alternating cross pattern
to 20 ft.-lbs. (27 Nm).
Splined Drive
Timing Dot
RR0627.eps
Timing Dot on Output Shaft
Screw hole that is aligned
with port surface.
Port
Surface
11
RR0674.eps
10
Splined Drive
Summary of Contents for 14J Series
Page 2: ...BLANK...
