8
DECORATIVE SCROLL ASSEMBLY
PIPE SCROLL HARDWARE
MOUNTING BRACKET INSTALLATION (CONT.)
Step 3.
Align the slotted holes in the ceiling plate
with the pilot holes you drilled in the wood support
structure� For proper alignment use slotted holes
directly across from each other�
Note:
The isolators should be flush against the
ceiling�
Step 4.
Place a flat washer on each of the two
3” wood screws and pass the screws through the
slotted holes in the ceiling plate into the pilot holes
you drilled�
Step 5.
Tighten the screws into the 9/64” pilot
holes; do not use lubricants on the screws� Do not
over tighten�
Joist
Ceiling Fan
Approved
Wiring Box
Washer
Wood
Screw
Allen
Wrench
ALLEN SET
SCREW
(pre-installed)
Collar
Decorative Scroll
Screws (5)
Decorative Scroll
Arm (5)
Note: On sloped ceilings, align
the canopy opening toward
the top or peak of the room�
Screwdriver
Canopy
Scroll to Motor
Screws (5)
Trim Ring
Note:
Decorative Scroll Work can only be installed
on ceilings at least 10' high�
Step 1.
Using the Allen Wrench, loosen the Set
screw on the collar of the Scroll Assembly�
Step 2.
Attach Scroll Arm to Collar with Scroll
Screw�
Step 3.
Repeat step 2 until all (5) Scroll Arms are
attached to the Collar�
Collar
Set Screw
Scroll Screw
Decorative
Scroll Arm
Allen
Wrench
