21
Direct - Touch
1
2
0
4
3
W-74
Wall Control
BLACK AND WHITE
STRIPED WIRE
2 RED WIRES
2 BLACK
WIRES
6.
Remove the two remaining wires from the three-way
switch� Connect the black wire of these wires to a black
wire on the W-74 control� Secure the splice with a wire nut�
The remaining red wire is to be connected to the other red
wire on the
W-74� Secure the splice with a wire nut� Figure 5
7.
Connect the green ground wire coming from the back of the
W-74 control to the ground wire in the switch box� Secure
the splice with a wire nut�
8.
Check your work by using the wiring diagrams as shown in
Figures # 4 and #5 on this page�
9.
Install the W-74 in the wall box with the two long screws
provided�
10.
Install the wall plate with the two short color-matched
screws provided�
11.
Installation of the second W-74 control is identical� Repeat
steps 1 through 7�
OPERATION POWER
The
1
2
0
4
3
power button is normally left in the on position� Always turn the
power off during cleaning or servicing the fan and during thunderstorms� It
is also used to exit or enter additional programs�
The
1
2
0
4
3
power button must be left on to retain a previously set fan speed
or light level�
OPERATION SPEED CONTROL
There are five individual speed settings for the fan� Each speed is
indicated by the number on the controller and an audible tone for
each speed�
To select the desired fan speed:
Press the number on the controller corresponding to the speed
desired� 4 is high, 3 medium, 2 low, 1 ultra-low, and 0 is off�
OPERATION REVERSING AIRFLOW
The direction of airflow can be changed from downward to upward
or from upward to downward�
To reverse the airflow:
1.
Make sure the fan is on and blades are turning�
2.
Press the
1
2
0
4
3
reverse button� You will hear a series of clicks
from the fan as it speeds up before coming to a stop and
changing direction�
1
2
0
4
3
1
2
0
4
3
1
2
0
4
3
Note: It is normal for the fan
to start in the "High" position
from "Off" before changing to
the selected speed�
W-74 OPERATION
Figure 5
