23
Direct - Touch
1
2
0
4
3
1.
Turn power OFF at the circuit breaker or fuse box and at the toggle
switch, for the fan you want to change�
2.
Remove the screws and switch plate from the existing switch box�
3.
Remove the screws holding the switch in the switch box�
4.
Pull the existing W-74 switch from the switch box to expose the dip
switches located on the side of the control as shown in Figure #1�
5.
Change the dip switch settings, assuring that they are different from
the previously installed Direct-Touch fan�
6.
Mount the W-74 Wall Control unit back into the wall electrical box�
7.
At the circuit breaker or fuse box and at the toggle switch, turn the
power off for the fan whose frequency you are changing�
8.
Within 20 seconds of restoring power to the ceiling fan and the W-74
Wall Control press and hold both the “1” and
1
2
0
4
3
reverse buttons
as shown in Figure #2� For 3 seconds, you will hear one tone from
the Piezo Buzzer indicating the command has been accepted� The Fan
and Lights will be off�
AUTOMATIC DEMONSTRATION PROGRAM
Programmed into every Direct-Touch fan is an Automatic Demonstration
Program� It can be used to fully demonstrate and test the operation of the
fan�
To enter the demonstration program:
1.
Turn the
1
2
0
4
3
power button off for at least 5 seconds� This will clear
the fan memory ready for programming�
2.
Turn the
1
2
0
4
3
power button on�
3.
Immediately hold the "0" button for at least 5 seconds�
A multi-tone signal will verify the start of the test program� The fan and
lights will go through a series of changing fan speeds, reversing the fan
operation mode, turning off/on, and dimming the lights�
The complete cycle lasts slightly over one minute� It will continue to
repeat until the
1
2
0
4
3
is turned off for more than five seconds, cancelling
the program�
OPERATION SAFE-EXIT®
The Safe-Exit Program gives you about thirty seconds of light when you turn the
lights off, enabling you to exit your home before the lights go out� To enter the Safe-
Exit Program:
1.
Press the
1
2
0
4
3
power button off for at least five seconds�
2.
Turn the Power on� Immediately press and hold the "4" button for 5 seconds�
When a light button is pressed, an audio tone and series of lights blinking will indicate the program
is active� When CFL mode is disabled, the Lights will stay on at 50% brightness for 20 seconds then
decrease in intensity for 30 seconds then turn off�
3.
With CFL mode active, the lights will turn off after 30 seconds�
4.
To cancel the Safe-Exit Program, press the
1
2
0
4
3
power button and leave off for five seconds�
Safe-Exit
(Figure 2)
1
2
0
4
3
Note: With CFL mode active,
the lights will not dim�
