MANUAL SOUND SETUP
36
seconds through all the speakers connected.
The unit cycles through the speakers in the following sequence:
FRONT LEFT > CENTER > FRONT RIGHT > SURROUND RIGHT > SURROUND BACK
RIGHT > SURROUND BACK LEFT > SURROUND LEFT > SUBWOOFER
7.
Use the
and
buttons on the remote to adjust the speaker level.
You can adjust the selected channel level in 0.5dB steps across a range of -15dB to
+15dB. The unit will then resume cycling the Test Tone from speaker to speaker.
8.
When you have finished adjusting the levels for all of the speakers within your system,
press the
button on the remote to select BACK, then press ENTER to return to the
previous “SETUP MENU” to continue through the system setup process, or simply press
the SETUP button to exit the “SETUP MENU” completely.
SET CROSSOVER POINTS
The LPF/HPF (Low Pass Filter/High Pass Filter) Crossover menus are used to independently set
the internal High Pass filter of the Cinema 11a each of the speakers.
Setting the Speaker Crossover Points
In the Cinema 11a, the Crossover Points can be selected in 10Hz increments within a 40Hz to
150Hz range, or each speaker can be set to receive full range signal. Select the crossover point
closest to the low-frequency rating of the associated speaker. For instance, set to FRONT L/R
parameter to the crossover point closest to the low-frequency rating of the front speaker.
Select the subwoofer crossover point equal to the lowest crossover point of the other speakers.
In general, low frequencies will be redirected from the speakers with the highest crossover points
to the speakers with the lowest crossover points. Low-frequency signals lower than the lowest
crossover point will be redirected to the subwoofer.
NOTE: The following selected menus appear on the Cinema 11a Display:
MOVIE SPK Setting
Set Crossover Points
To set the crossover points for your speakers:
1.
Press the SETUP button to enter the “SETUP MENU”.
The “SETUP MENU / LISTENING PROFILES” menu appears on the front panel display.
2.
Press the ENTER button on the remote to enter the “LISTENING PROFILES” setup menu.
The “LISTENING PROFILES / MOVIE MODE” menu appears on the front panel display.
3.
Press the ENTER button on the remote to enter the MOVIE MODE “Set Speaker Config”
settings menu.
The “MOVIE SPK Setting / Set Speaker Config” menu appears on the front panel display.
