Wheel balancer 80-2000T. Operation Manual
p.37
37
10 MAINTENANCE AND SAFETY REQUIREMENTS
10.1 Maintenance
10.1.1 The maintenance of the machine is the necessary condition for providing the
correct operation of the machine; the maintenance shall be fulfilled by the operating staff in
accordance with the present manual.
10.1.2 IMPORTANT! DEENERGIZE THE MACHINE BEFORE PERFORMING THE
MAINTENANCE.
10.1.3 Keep the machine clean and free of dust and moisture. Do not flood or sprinkle the
machine with water. Do not use acetone or other solvents for wiping the machine.
10.1.4 Check the spindle bolt tightening frequently.
10.1.5 Keep the thread segment of shaft clean and lubricated.
10.1.6 Eliminate the faults, indicated in the Table 9.2. Contact after-sales service office in
the other cases.
10.1.7 It is not allowed to dismount the machine till the end of the warranty period.
10.1.8 In case of insufficient precision of measurements during the operation, check the
machine and, if necessary, calibrate the machine.
10.1.9 Monthly check shaft imbalance and make shaft calibration by necessity.
10.1.10 Air preparation system maintenance
Check oil level in air-oil lubricator frequently twice a month. Oil level shall be beyond the
breather. Fot oil filling turn the cap off.
Every 3-4 days check, that upon every second or third push on pneumatic switch, oil drop
shall drop in transparent bowl of air-oil lubricator. Otherwise, adjust set screw of air-oil lubricator
using screw-driver.
Check the amount of condensed fluid in filter bowl. Drain the condensed fluid if necessary.
To drain condensed fluid turn slotted nut counterclockwise.
10.2 Safety requirements
10.2.1 The operating personnel shall read the present Manual and be aware of the
machine operation features. The operating staff shall be also given the safety guidance
instructions.
10.2.2 The machine should be grounded in accordance with electrical equipment operation
rules. The grounding of the machine is effected automatically upon plugging in. When installing
the machine, make sure that the plug grounding is in good condition.
10.2.3 The machine shall be operated in accordance with the Safety Rules related to
operation of electrical equipment.
10.2.4 IMPORTANT! THE VOLTAGE INSIDE THE MACHINE CAN BE UNSAFE. MAKE
SURE THAT THE UPPER COVER OF THE MACHINE IS CLOSED DURING THE
OPERATION.
10.2.5 De-energize the machine before starting the maintenance works.
10.2.6 IMPORTANT! IT IS NOT ALLOWED TO STAND IN THE AREA OF ROTATING
PARTS DURING THE OPERATION. During the wheel setting on the machine it’s necessary to
check the security of wheel attachment in order to avoid skipping of the wheel.
It is not allowed to brake the wheel with the hand.