Wheel balancer 80-2000T. Operation Manual
p.28
28
Movement smoothness may be improved if in the result of the optimization the heaviest
place of the tyre (more solid or higher) will align to the place of the minimal rim diameter.
It’s recommended to fulfil the optimization in case of the large wheel imbalance and high
requirements to movement smoothness.
The optimization process is fulfilled in the optimization mode in the following way:
- measure the initial imbalance;
- turn the tyre relative to the rim by 180
;
- measure the imbalance;
- the machine calculates the new tyre position;
- turn the tyre relative to the rim to the new position;
- fulfil the imbalance control measurement.
During all measurements of the imbalance the wheel should be pumped up to the norm, all
weights should be taken off.
The optimization may be fulfilled after the imbalance measurement before the weights
setting.
Press the button
OPTIMIZE
.
Fulfil operations in accordance with displayed instructions.
After termination - balance the wheel in accordance with the usual procedure.
In the process of optimization while the tyre turning the other tyre fitter may balance
another wheel on the machine. For this purpose it’s necessary to switch over to the other
«operator» - press the button
OPERATOR
(according to 7.3). In order to continue the
optimization it’s necessary to revert to your «operator» - press the button
OPERATOR
.
7.5 Adaptor imbalance compensation
Any adaptor mounted on the shaft introduces its own imbalance.
For adaptors mounted on the shaft by means of bolts through slots in the shaft cup,
influence of this imbalance on the wheel balancing quality may be eliminated.
For this purpose it’s necessary to fulfil the procedure of the adaptor imbalance
compensation.
Fasten the adaptor on the shaft.
Press the key
ADAPTER
.Then after the request on the display lower the cover
for the imbalance measurement. After the shaft stops the indicator of the adaptor compensation
will glow (will become contrast) in the information field
.
Mount wheels on the adaptor and balance them according to the usual procedure.
Disable the adaptor compensation mode after the adaptor removal.
To disable the adaptor compensation press the key
ADAPTER
and press
ESC
. After that the adaptor compensation mode indicator will go out (will become pale)
.
The adaptor compensation procedure should be fulfilled before the wheel mounting!
If the adapter's imbalance does not exceed 3 g adaptor compensation is not necessary.
