Wheel balancer 80-2000T. Operation Manual
p.23
23
Figure 6.3 - The weight is set in the position “12 h”
Lower the cover for check measurement. Wait for the wheel stop. Raise the cover.
The information on weights will be imaged on the display. If the result is no equal «0 - 0»
set additional weights or change the position of the existing ones and repeat the check
measurement.
6.2 Alloy wheel (ALU) balancing
Let’s consider the wheel balancing with the weight scheme shown in Figure 6.4. The
machine is adjusted for setting of stick-on weights in "12 h" position, SmartALU mode is
switched off.
Figure 6.4
If the machine is not in the state «New wheel» change to this state. If it’s for example, in
the weight setting state, then press
NEW WHEEL
.
Press
STOP
for temporary brake actuation.
Mount the clean wheel on the shaft (Figure 6.5).
Figure 6.5 - Wheel mounting
Enter dimensions. For this purpose place the gauge arm to the rim (Figure 6.6a) and hold
it in this position until a signal is heard. Return the gauge arm to the initial position.
Possible weight setting schemes and width will appear on the display.
Press keys
ALU
and
ALU
to choose the scheme.
It is not necessary to enter width.
