![background image](http://html1.mh-extra.com/html/carrier/truvu-vavb3-e2/truvu-vavb3-e2_installation-and-startup-manual_2562517096.webp)
To set up the controller through the Comm/Service ports
TruVu™ VAVB3
-E2
CARRIER CORPORATION ©2022
Installation and Start-up Guide
All rights reserved
90
BACnet tab
NOTE
The TV-VAVB3-E2 can be configured for only one BACnet communication type.
On the
BACnet
tab, you can choose to run
BACnet Over IP
or
BACnet Over Ethernet
on the
Eth0
and
Eth1
ports.
If you choose
BACnet Over IP
, you can edit the
BACnet UDP Port
.
Security tab
BACnet Firewall
If your BACnet Firewall configuration in the i-Vu® interface did not include the i-
Vu® server IP address, thus blocking communication with the i-Vu® server, you
can disable the controller's BACnet Firewall on the controller setup
Security
tab.
NOTE
You can enable the BACnet Firewall only in the i-Vu® interface.
Local Network tab
Use the
Local Network
tab to:
•
Discover 256 i-
Vu® XT or TruVu™ devices on a s
ingle network at a time.
•
Discover both configured or unconfigured devices on this controller's network.
•
See the number of devices discovered and the total number on the network.
•
Identify the i-
Vu® XT or TruVu™ controller that has had its DSC button presse
d.
•
Export the
Local Devices
that are present in the table (limited to 256) to a .csv file.
•
Set a device's
Mode
,
Address
, and
Location
.
•
Assign IP addresses to multiple devices at one time.
•
Prompt an LED to flash on a device.
A device that is new from the factory or has not been previously configured with an IP address, can always be
configured using the
Local Devices
table. However, once you have assigned a valid IP address, you have up to 24
hours to make any other changes. After 24 hours, the fields are not editable and the device is
Locked
.
You can unlock a device for 24 hours by either pressing the DSC button on the TV-VAVB3-E2 controller or by using
the i-Vu® application. In the i-Vu® navigation tree, right-click the TV-VAVB3-E2, select
Driver Properties
and go to
Driver
>
Settings
tab >
Local Network Configuration
. Check
Allow Local Network Configuration from other
devices on the local network for 24 hours
and click
Accept
.