![background image](http://html1.mh-extra.com/html/carrier/ndk33bn0kb/ndk33bn0kb_operation-and-service-manual_2563853148.webp)
62-61753-21
7-32
Alarm
NO.
Steps
ALARM / CAUSE
CORRECTIVE ACTION
41
ENGINE STALLED
TRIGGER-ON: The engine is running, RPM sensor is good, and engine speed is less than 10 RPM;
or
The engine is running, RPM sensor alarm is ON, and the Oil Pressure switch contacts are open.
UNIT CONTROL:
Engine Operation: Engine and unit shutdown and alarm.
Standby Operation: This alarm will not activate in standby operation.
RESET CONDITION: Auto Restart after 15 minutes, or Alarm may be manually reset via keypad or by
turning the unit off, then back on again.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active
alarm should clear itself (refer to reset condition above). Operate the unit through the appropriate modes to see if
any active alarm occurs. Continue with the steps below as necessary.
1
Check For Alarm 130 - Check RPM Sensor
a. Check for alarm 130.
When Alarms 130 and 41 occur at the same time, gen-
erally the engine has run out or is running out of fuel.
This causes the engine RPM to surge and drop. Check
fuel tank and add fuel as necessary.
Check fuel lines between the fuel tank and the fuel
pump inlet for drawing air in.
2
Was Engine Shut Off Manually?
a. Check for external cause.
Correct problem.
3
Check For Bad F2 Or F3 Fuse Alarm
a. Check for alarm 71.
Alarm conditions must be corrected and the alarm
cleared to continue.
4
Check Fuel System
a. Check for Alarm 1.
Fill tank as needed.
b. Check fuel flow.
Unrestricted fuel flow through system.
Fuel not gelled.
c. Check fuel system prime.
No air in fuel system.
d. Check fuel system check valve
from filter to injection pump.
Check valve must hold fuel and not leak back.
5
Check engine air-intake system
a. Check air filter.
Replace if required.
b. Inspect air intake system.
Hoses & tubes in good condition.
No kinks or restrictions.
6
Check engine exhaust system
a. Inspect the exhaust system.
Must be clear and unobstructed.
7
Check engine
a. Check Injection pump timing.
Timing must be correct.
b. Check engine valve adjustment.
Rocker arm clearance must be correct.
c. Check engine compression.
Compression must be above 400 psig (27.2 bar.)
8
Check refrigeration system
a. Check discharge & suction pres-
sures.
Must be within normal operating range for conditions.
Summary of Contents for NDK33BN0KB
