![background image](http://html.mh-extra.com/html/carrier/connect-33connectstat43fx/connect-33connectstat43fx_installation-manual_2564065034.webp)
Using installer settings
Carrier Connect™ Wi
-Fi Thermostat 33CONNECTSTAT43FX
CARRIER CORPORATION ©2021
Installation Guide
All rights reserved
30
Setting
Default/Range
PROGRAMMABLE OR NON-PROGRAMMABLE
—
Set the thermostat to operate as a non-
programmable (simplified) thermostat or a programmable thermostat.
Operating the thermostat in a programmable mode allows the end user to setup heating
and cooling setpoints for 2 or 4 periods of each day of the seven days of the week.
The thermostat has default heating and cooling setpoints outlined in the
Default Setpoint
Times and Temperature Settings
table shown below.
The program heating and cooling setpoints and transition times for the 2 or 4 periods can
be viewed or modified in
PROGRAM SCHEDULE
(page 22) on the thermostat.
Choosing the non-programmable mode for the thermostat allows it to run in a simplified
mode that will satisfy heating or cooling setpoints based on the setpoint value and mode.
When the thermostat is set to
NP
(non-programmable):
•
OCC
/
UNOCC
/
RESUME SCHEDULE
button is not displayed on the home screen.
•
OCCUPIED
,
UNOCCUPIED
, and
SCHEDULE PAUSED
icons are not displayed on the
home screen.
•
The program schedule cannot be viewed.
When the
REMOTE SENSOR
setting is set to
OCC
(Occupancy), this setting is forced to
NP
and is not displayed to the installer.
Default setpoint times and temperature settings
Setting
Start time
Heat setpoint
Cool setpoint
1st Period
7 AM
70°F
75°F
2nd Period
5 PM.
62°F
85°F
3rd Period
10 PM
70°F
75°F
4th Period
11 PM
62°F
85°F
D:
R:
PROG
PROG
(programmable
thermostat)
NP
[non-
programmable (simplified)
thermostat]
MAXIMUM HOLD HOURS
—
Set the amount of time, in hours, that a setpoint change
overrides the program schedule.
Range
•
OFF
- When set to
OFF
, the setpoints cannot be changed from their program
schedule values.
•
1
to
6
- User setpoint change remains active for this number of hours and then the
setpoint returns to the
PROGRAM SCHEDULE
setpoints.
NOTE
This selection is not available if the thermostat has been configured as non-
programmable.
D:
R:
2 Hours
OFF
1 - 6
F OR C UNITS
—
Sets the temperature units to either F (Fahrenheit) or C (Celsius).
D:
R:
F
F/C
Summary of Contents for Connect 33CONNECTSTAT43FX
Page 4: ......
Page 68: ......
Page 69: ......
Page 70: ...Carrier 2021 Catalog No 11 808 872 01 12 3 2021 ...