![background image](http://html1.mh-extra.com/html/carrier/appcontroller-opn-app/appcontroller-opn-app_installation-and-startup-manual_2562431017.webp)
Installing the AppController
AppController
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
11
4
Connect the binary output wiring to the screw terminals on the AppController and to the controlled device.
5
Insert the power screw terminal connector into the AppController's power terminals.
Wiring devices to the AppController's Rnet port
The Rnet communicates at a rate of 115 kbps and should be wired in a daisy-chain or hybrid configuration.
Supports up to
10 wireless and/or ZS sensors (5 per control program)
One Equipment Touch
One TruVu™ ET Display
NOTE
ZS sensors, a Wireless Adapter, and an Equipment Touch can share the Rnet, but not SPT sensors.
Rnet wiring specifications
NOTE
Use the specified type of wire and cable for maximum signal integrity.
Description
4 conductor, shielded or unshielded, CMP, plenum rated cable
Conductor
22 AWG (7x0096) bare copper if Rnet has only sensors
Maximum length
500 feet (152 meters)
Insulation
Low-smoke PVC (or equivalent)
Color Code
Black, white, green, red
Shielding
If shielded, Aluminum/Mylar shield (100% coverage) with TC drain wire, terminated
at controller
UL temperature rating
32
–
167°F (0
–
75°C)
Voltage
300 Vac, power limited
Listing
UL: NEC CL2P, or better