Installing the AppController
AppController
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
4
1
Mount the controller
(page 4).
2
Wire the controller for power
(page 5).
3
Set the controller's address
(page 5).
4
Wire the controller to the BACnet MS/TP or BACnet ARC156 network
(page 6).
5
Wire inputs and outputs.
(page 7)
6
Wire devices to the controller's Rnet port
Mounting the AppController
WARNING
When you handle the AppController:
•
Do not contaminate the printed circuit board with fingerprints, moisture, or any foreign material.
•
Do not touch components or leads.
•
Handle the board by its edges.
•
Isolate from high voltage or electrostatic discharge.
•
Ensure that you are properly grounded.
Screw the AppController into an enclosed panel using the mounting slots on the coverplate. Leave about 2 in. (5
cm) on each side of the controller for wiring. Mounting hole dimensions 5 9/16" (14.1 cm) between mounting slot
center lines.
Installing the AppController