Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
20
SPEEDCHECK-15/18 USER MANUAL
3.0 COMPONENTS AND PREPARATION
3.8 Controller – Programmable (Legacy)
The controller below is being phased out and replaced by the updated programmable board (
Status LEDs:
•
Power LED = input power; this will illuminate when power is applied
•
Coin Cells LED = coin cells active; this will illuminate when input power has been removed and coin cells
are actively keeping date/time
•
Bluetooth LED = Bluetooth connection; this will illuminate when a Bluetooth connection is active
•
Top Status LED = radar active; this will illuminate when the radar is powered and operational
•
Middle Status LED = vehicle detect; this will intermittently illuminate when a vehicle has been detected
•
Bottom Status LED = display active; this will illuminate when the display is powered and operational
Momentarily shorting the two bottom pins on the 10-pin serial connector will perform a reset.
The coin cell bypass jumper must be present for the system to power up if the coin cells are
dead or removed.
Coin cells are installed with the positive side facing up or towards the outer edge of the
controller PCBA.
POWER
INPUT
RADAR
INPUT
OUTPUT TERMINAL
(BEACONS AND STROBES)
INPUT TERMINAL
(EXTERNAL INPUT)
DISPLAY
LEDS
COIN CELL BYPASS
(ENSURE THIS
JUMPER IS PRESENT)
COIN
CELLS
COIN CELLS
LED
BLUETOOTH
LED
STATUS
LEDS
POWER
LED
10-PIN SERIAL
TERMINAL
(FOR THIRD PARTY
CONNECTIVITY)
