Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
25
SPEEDCHECK-15/18 USER MANUAL
4.0 INSTALLATION
4.3 Flat Surface Mount Installation
1. Attach the two “L” shaped brackets to a suitable pole such as 2” Telespar with 1” standard spacing
between holes. Ensure there is 16” between the two inner-most bolt locations. The upper “L” bracket uses
the 2
nd
and 4
th
holes from the top of the bracket, and the lower “L” bracket uses the 1
st
and 3
rd
holes from
the top of the bracket.
2. Attach the flat rotational plates to the top and bottom of the SpeedCheck sign using the provided eight ¼”-
20 X 0.5” hex head (5/32” drive) screws.
3. Attach the rotational plates to the “L” brackets by aligning the centrally located pivot bolt holes. Rest the
upper plate on top of the upper “L” bracket, and the lower plate on top of the lower “L” bracket then loosely
secure them finger tight using the provided 5/16”-18 X 1” nuts and bolts in the pivot bolt holes.
4. Align the display sign to aim at the oncoming vehicles by installing two sets of nuts and bolts to both upper
and lower plates.
5. Tighten all fasteners in an alternating manner until they are all completely tight.
Through bolts for square pole mounting are not provided. Recommended bolt size is 3/8”-16.
Ensure that three nuts and bolts are used between each flat bracket and pole bracket.
Legacy versions of the “L” brackets have two holes oriented vertically instead of four. Two-hole
versions are used with SPEEDCHECK-15 display enclosures that have an angled top.
16 IN.
Top Mount
Bottom Mount
