Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
29
SPEEDCHECK-15/18 USER MANUAL
4.0 INSTALLATION
4.7 Cabinet Installation
Before mounting the cabinet to the pole, all wiring internal to the pole (power, LED, optional
StreetHub™ serial and ground cables) should be fished.
1. Loosen four nuts on back of cabinet and spread brackets outward. Tighten nuts to 20 ft-lb.
On the back of the cabinet, there are 2 drill points that may be used for routing of liquid-tight
conduit external to the mounting pole. Prior to drilling the cabinet, ensure there are no
components which may be damaged on the inside of the cabinet.
2. Drill a 1-3/4” diameter hole in pole for cabinet pipe nipple at desired position. An optional hole plug kit is
available if the pipe nipple is removed from the cabinet.
3. Route cables from pole into cabinet and temporarily affix cabinet against the pole. For U-bolt mounting,
install U-bolts, washers and nuts then torque to 30 ft-lb. For banding, install banding through openings in
brackets.
4. If desired, before tightening banding, brackets and banding can be adjusted inboard again. Tighten
banding (up to ¾” wide) as per banding manufacturer’s instructions.
