Carl Valentin APL 100, Operating Manual

Page: 51 / 58

Applicator APL 100 Error Messages
11/13 Operating Manual 51
11 Error Messages
11.1 Error Messages of the Printer
In case an error occurred the printer stops and the print order is
interrupted. Information to causes and remedies of printer errors e.g.
no label found
are to be taken from the printer manual.
1. Clear the error.
2. Press the key to synchronize the label feed.
3. Remove the peeled labels manually.
4. Press the key to quit the error state.
5. Press the key to continue the print order or press key
to cancel the print order.
11.2 Error Messages of the Applicator
Error message Cause Remedy
Upper position
The upper position (start position)
was not reached. Check final position switch for start
position and compressed-air supply.
Adjust stroke timeout.
Lower position
The lower position (labelling
position) was not reached. Check final position switch for labelling
position and compressed-air supply.
Adjust stroke timeout.
Empty vacuum
plate
Sensor does not recognize a label at
the vacuum plate. Check if all holes of the pad plate are
covered from the label.
Check compressed-air supply.
Print position
At print start the pad is not in printing
position (upper pad position). Check the correct function and position
of the final position switch for the upper
position (start position).
Check the pneumati function.
CAUTION!
The pad will immediately be moved in the starting position.
Danger of crushing to hand and fingers by the moving pad.

Do not reach into the zone of the moving pad.

Keep long hair, loose clothes and jewellery distant from
the zone of the moving pad.
Danger of striking by the moving rods.

Do not reach or bend into the zone of the moving rods.
After error correction, the print of the label causing the error cannot be
repeated without re-start of the print order.