Carl Valentin APL 100, Operating Manual

Page: 24 / 58

Installation Applicator APL 100
24 Operating Manual 11/13
4.6 Mounting the Stopper
NOTICE!
In the operating modes 'Stamp on' and 'Roll on' the stopper is
not needed.
2 1 3
4
3
1
Figure 13
When the applicator is delivered, the stopper (1) is mounted on the
rods (4). With this stopper the labelling position for the operation mode
'Blow on' can be adjusted.
1. Slide the stopper (1) with the rubber buffer (2) down onto the rods.
2. Adjust the stopper (1) (see chapter 7.5, page 37).
In the operating modes 'Stamp on' and 'Roll on' the stopper is not
needed. The stopper may not limit the pad movement.
1. Loosen the screw (3) at the stopper (1).
2. Slide the stopper (1) as far as possible upwards and tighten the
screw (3).
or
3. Remove the stopper (1) upwards from the rods (4).
Operating mode
'Blow on'
Operating modes
'Stamp on' and
'Roll on'