Carl Valentin APL 100, Operating Manual

Page: 37 / 58

Applicator APL 100 Mechanical Adjustments
11/13 Operating Manual 37
7.5 Adjusting the Stopper
NOTICE!
For operating mode 'Blow on' only.
3
2
1
4
5
6
7
Figure 22
CAUTION!
Danger of injury by inadvertent move out of the cylinder.

Switch off the printer and close the shutoff valve for
the compressed air at the service unit.
1. Place a product sample (7) at the labelling point.
2. Pull the tubes out of the push-in-fittings (1,5).
3. Loosen the screw (3) in the stopper (2).
4. Move the pad manually in the required labelling position. The
distance between the blow pad (6) in the labelling position and the
product surface (7) must not exceed 10 mm.
5. Move the stopper (2) against the guide block (4) and tighten the
screw (3).
6. Insert the tubes into the appropriate push-in-fittings (1,5).
7. Open the shutoff valve and switch on the printer.